Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER manual Remote Connections on the Back Panel

Models: EVOLUTION TWO MONAURAL PREAMPLIFIER

1 60
Download 60 pages 32.3 Kb
Page 28
Image 28
37, 38 Record Bus Outputs

(SECTION FOUR: Anatomy of an Evolution Two continued)

(Outputs continued)

37, 38 Record Bus Outputs

The Evolution Two is equipped with one balanced record bus output with XLR connectors and one single-ended record bus output with RCA connectors. Use the record bus outputs to record a input signal other than the signal playing on the main outputs. For more information, see Play and Record, on page 30.

39, 40 Main Outputs

The Evolution Two is equipped with one balanced output with XLR connectors and one single-ended output with RCA connectors.

41CAST Outputs

The Evolution Two is equipped with two CAST preamplifier outputs with 4-pin bayonet connectors, for use with Krell CAST-equipped amplifiers.

Remote Connections on the Back Panel

42RC-5 In

Each Evolution Two preamplifier chassis (1) has an RC-5 remote input. The RC-5 remote connector is used with a third party remote control system that provides RC-5 (IR) data with the carrier intact, via a wired connection. A stereo tip, ring, sleeve 1/8mini connector is used in the following configuration: Tip = RC-5 data, Ring = +5 V, Sleeve = GND.

43RS-232

Each Evolution Two preamplifier chassis (1) has an RS-232 port that receives messages from a computer-based control system, providing integrated control of all preamplifier functions. The RS-232 input uses a 9-pin D-subminiature connector. See the Evolution Two developer's reference, entitled RS-232 Port: Sending Commands and Interpreting Data, for more information.

4412 VDC In/Out (12 V Trigger)

Each Evolution Two preamplifier chassis (1) has 2 outputs that send and one input that receives 12 VDC power on/off (12 V trigger) signals to and from other Krell components and other devices that incorporate a 12 V trigger. This allows you to turn other components on or off, or to and from stand-by, through the remote control. When the Evolution Two is switched to operational mode and is connected to other components through the 12 V trigger, it sends a signal that will switch other components, allowing whole systems or parts of

24

Page 28
Image 28
Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER manual Remote Connections on the Back Panel, 37, 38 Record Bus Outputs

FAQ

What are the record bus outputs for?

The record bus outputs are used to record an input signal other than the signal playing on the main outputs.

How many main outputs does the Evolution Two have?

The Evolution Two has one balanced output with XLR connectors and one single-ended output with RCA connectors.

What is the 12 V trigger for?

The 12 V trigger allows you to turn other components on or off, or to and from stand-by, through the remote control.