Kyocera FS-1010 manual 2 RS-422A Interface, SG Signal Ground Pin, DTR Data Terminal Ready Pin

Serial Interface (Option)

SG - Signal Ground - (Pin 7)

All signals can transmit between the printer and the host computer to send each signal with a signal ground.

DTR - Data Terminal Ready - (Pin 20)

This output is used as a buffer nearly-full handshake line. It is held high (above 3 volts) when the buffer can accept more data.

RS-232C Interface Voltage Levels

The voltage levels of the interface signals conform to EIA RS-232C specifications. SPACE is from 3 volts to 15 volts. MARK is from -3 volts to -15 volts. Voltages between -3 volts and 3 volts are undefined.

B.3.2 RS-422A Interface

The serial interface is set to the RS-232C mode as the factory default. However, by changing the jumper connector on the IB-10E interface board, the interface can be changed to the RS-422A mode.

In the RS-232C mode, the printer can be connected to a personal computer (or similar device) equipped with an RS-232C serial interface. (The serial interface is set to the RS-232C mode as the factory default.)

In the RS-422A mode, the printer can be connected to a personal computer (or similar device) equipped with an RS-422A serial interface.

Changing of the jumper connector should be carried out only by a Kyocera Mita authorized dealer or Kyocera Mita certified technician. Kyocera Mita shall not be liable for damage due to improper changing of the jumper connector.

Interface Signals

The pins in the printer’s RS-422A interface connector carry the signals listed in Table B.4.

Table B.4 RS-422A Signal Pin Assignments

Pin	In/out	Signal	Description
1	-	FG	Frame ground
3	In	RDA	Receive data Inverted
7	-	SG	Signal ground
9	Out	SDA	Send data Inverted
10	Out	SDB	Send data
11	-	-	+5V DC
18	In	RDB	Receive data

B-8