3. 2 Service Call Errors
You will note an error message “A significant error occurred. Call the service” on the operation panel if the machine has the fatal error.
At this time one of the following sub messages is displayed also.
Counter Error
Cutter Error
Developer Motor Error
FPGA Error
Fuser Low temp
Fuser Motor Error
Fuser Over temp
HV Charger Error
License Key Error
Main Motor Error
PLEASE CALL YOUR TRAINED SERVICE PERSONNEL TO RESOLVE THESE ERRORS.
If any of the above errors is displayed:
1.Turn off the machine, wait approximately 30 seconds, and then turn on the machine again.
2.If the same error message is displayed, turn off the machine, and then unplug the machine from the wall outlet.
Call your service personnel.
Chapter 3 Error Correction |
