LaCie Slim DVD±RW • Design by Sam Hecht | Foreword | |
User Manual | page 2 | |
|
|
|
Copyrights
Copyright © 2011 LaCie. All rights re- served. No part of this publication may be reproduced, stored in a retrieval sys- tem, or transmitted in any form or by any means, electronic, mechanical, photo- copying, recording or otherwise, without the prior written consent of LaCie.
Trademarks
Apple, Mac, and Macintosh are registered trademarks of Apple Inc. Microsoft, Win- dows, Windows XP, Windows Vista, and Windows 7 are registered trademarks of Microsoft Corporation. All trademarks mentioned in this manual are the property of their respective owners.
Changes
The material in this document is for in- formation only and is subject to change without notice. While reasonable efforts have been made in the preparation of this document to assure its accuracy, LaCie assumes no liability resulting from errors or omissions in this document, or from the use of the information contained herein. LaCie reserves the right to make changes or revisions in the product design or the product manual without reservation and without obligation to notify any person of such revisions and changes.
Canada Compliance Statement
This Class A digital apparatus meets all requirements of the Canadian Interfer-
Federal Communications
Commission Radio Frequency
Interference Statement (FCC)
Lacie Slim DVD±RW
Tested to comply with FCC standards for home or office use
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interfer- ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful in- terference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour- aged to correct the interference by one of the following measures:
✦✦ Reorient or relocate the receiving antennas.
✦✦ Increase the separation between the equipment and the receiver.
✦✦ Connect the equipment into an out- let on a circuit different from that to which the receiver is connected.
✦✦ Consult the reseller or an experi- enced radio/TV technician for help.
Shielded cables and I/O cards must be used for this equipment to comply with the relevant FCC regulations.
This device complies with Part 15 of the FCC rules. Operation is subject to the fol- lowing two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Manufacturer’s
Declaration for CE
Certification
We hereby certify that this device is in compliance with both the EMC Direc- tive (2006/95/EC) and the Low Voltage Directive (2004/108/EC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms:
Class B EN60950, EN55022, EN50082- 1,
Class I Laser product
This equipment is certified to comply with DHHS Rule 21 CFR Chapter I, subchapter J in effect as of the date of manufacture.
This equipment is classified as a Class I Laser product and no hazardous laser ra- diation is emitted outside the drive.
111220 v1.1
