Lanier AP2610 manual Cleaning and Adjusting the Printer, Cleaning the Friction Pad

Cleaning and Adjusting the Printer

Cleaning and Adjusting the Printer

Cleaning the Friction Pad

If the friction pad is dirty, a multi- feed or a misfeed might occur. In this case, clean the pad as follows:

A Lift the paper tray slightly then pull it out until it stops, and while lifting the front side of the tray, pull it out of the printer.

ZCEY140J

B Place the tray on a flat surface. When there is paper in the tray, remove paper.

C Wipe the brown part of the fric- tion pad with a soft damp cloth. After that, wipe it with a dry cloth to remove the water.

TS3Y250E

D Load paper into the paper tray with the print side up. Carefully slide the paper tray into the print- er until it stops.

ZCEY150J 5

Important

❒Do not slide the paper tray in with force. If you do, the front and side guides might move.

Note

❒If misfeeds or multi-feeds of pa- per occur after cleaning the fric- tion pad, contact your sales or service representative.

❒Follow the same procedure to clean the friction pad of the op- tional Paper Feed Unit and the Envelope Feeder Unit.

Important

❒Do not use chemical cleaner or organic solvent such as thinner or benzene.

93