Lanier AP2610 manual See 1394 Interface Unit Type

Error & Status Messages on the Control Panel

Messages/Second messages	Description	Solution
Hardware Problem	An error has occurred in the	First, turn the power switch
HDD	optional Hard Disk Drive.	off and then on, If the message
		appears again, call your sales
		or service representative.
		Turn off the power switch. Re-
		place the Hard Disk Drive and
		turn on the power switch. See
		“Hard Disk Drive Type 2600” in
		the Setup Guide.
		Turn off the power switch. Re-
		move the Hard Disk Drive
		and turn on the power switch.

		Note
		❒ If the Hard Disk Drive is
		not installed, you cannot
		send the sample print job,
		locked print job and
		download the font to Hard
		Disk Drive using the PS
		Utility for Mac.
Hardware Problem	An error has occurred in the	First, turn the power switch
IEEE1394	optional 1394 Interface Unit.	off and then on, If the message
		appears again, call your sales
		or service representative.
		Turn off the power switch. Re-
		place the 1394 Interface Unit
		and turn on the power switch.
		See “1394 Interface Unit Type
		4510” in the Setup Guide.
		Turn off the power switch, re-
		move the 1394 Interface Unit
		and turn on the power switch.

		Note
		❒ If you remove the 1394 In-
		terface Unit, you cannot
		send print jobs via the 1394
		Interface Unit. You can
		only send print jobs to the
		printer via the parallel ca-
		ble connection.
Hardware Problem	An error has occurred in the	Replace the IEEE 802.11b
IEEE 802.11b	optional 802.11b Interface	board.
	Unit.

5

63