Lanier AP2610 manual OHP transparencies, Adhesive labels, Envelopes, Metric version Inch version

Paper and Other Media

❖OHP transparencies

•Load only one OHP transparency at the same time onto the Bypass Tray.

•When loading an OHP transparency onto the Bypass Tray, set the printer to Transparency mode with the control panel.

•Be careful not to touch the print side of the OHP transparencies, otherwise the print side gets dirty or damaged, and results in poor print quality.

•When printing on an OHP transparency that has a print side, load it facing down onto the Bypass Tray.

❖Adhesive labels

3	• Load only one adhesive label at the same time onto the Bypass Tray.
	• Use adhesive labels in which the whole side can be printed on.
	• Do not use adhesive labels having exposed glue.
	• If the print side is coated, print quality might be reduced, as the toner
	might not fuse well.
	❖ Envelopes
	• When printing on envelopes, use the Bypass Tray or the Envelope Feeder
	Unit.
	• Even when the optional Envelope Feeder Unit is not installed, you can se-
	lect the sizes for the Envelopes for Tray 2 using the control panel. Howev-
	er, you cannot load the envelopes until optional Envelop Feeder Unit is
	installed.
	To use the Envelope Feeder Unit, installation of the optional Paper Feed
	Unit is required. See “Envelope Feeder Type 2600” in the Setup Guide.

• Specifications of envelopes are as follows:

	Metric version	Inch version
Weight	72 – 90 g/m2	19 – 24 lb. bond
Recommended weight	72 g/m2, 114 ⋅ 162 mm	24 lb. bond, 37/8 ⋅ 71/2 inches
and size	(C6 Env)	(Monarch)

• You can load up to 10 envelopes (72 – 90 g/m2, 19 – 24 lb. bond) onto the Bypass Tray at the same time, without forcibly pressing them. Confirm that the envelopes are not damp, and that the top of the stack is not higher than the limit mark on the side guide. See p.45 “Loading envelopes onto the Bypass Tray”.

• You can load up to 60 envelopes (72 – 90 g/m2, 19 – 24 lb. bond) into op- tional Envelope Feeder Unit at the same time, without forcibly pressing them. Confirm that the envelopes are not damp, and that the top of the stack is not higher than the limit mark on the side guide. See p.47 “Loading envelopes into the Envelope Feeder Unit”.

• Confirm that the print side is facing up when loading onto the Bypass Tray, and facing down when loading into the optional Envelope Feeder Unit.

34