Lenovo 23539KU manual Wireless LAN problem, Solution

Solution: Make sure that:

–The cable is installed properly.

The network cable must be securely connected both to the Ethernet connector of your computer and to the RJ45 connector of the hub. The maximum allowable distance from the computer to hub is

100 meters. If the cable is connected and the distance is within acceptable limits but the problem persists, try a different cable.

–You are using the correct device driver. To install correct driver, do the following:

1.Click Start, and then click Control Panel.

2.Click Hardware and Sound.

3.Click Device Manager. If you are prompted for an administrator password or confirmation, type the password or provide confirmation.

4.If the ! mark is to the left of the adapter name under Network adapters, you might not use the correct driver or the driver is not enabled. To update the driver, right-click the highlighted adapter.

5.Click Update Driver Software, and then follow the instructions on the screen.

–The switch port and the adapter have the same duplex setting.

If you configured the adapter for full duplex, make sure the switch port is also configured for full duplex. Setting the wrong duplex mode can degrade performance, cause data loss, or result in lost connections.

–You have installed all networking software that is necessary for your network environment. Check with your LAN administrator for the necessary networking software.

•Problem: The adapter stops working for no apparent reason.

Solution: The network driver files may be corrupt or missing. Update the driver by referring to the solution description above for the procedure to make sure that the correct device driver is installed.

•Problem: If your computer is a Gigabit Ethernet model and you use the a speed of 1000 Mbps, the connection fails or errors occur.

Solution:

–Use Category 5 wiring and make sure that the network cable is securely connected.

–Connect to a 1000 BASE-T hub/switch (not 1000 BASE-X).

•Problem: The Wake on LAN feature is not working.

Solution: Make sure that Wake on LAN is enabled in ThinkPad Setup. If it is, check with your LAN administrator for the necessary settings.

•Problem: If your computer is a Gigabit Ethernet model, it cannot connect to the network at 1000 Mbps. Instead, it connects at 100 Mbps.

Solution:

–Try another cable.

–Make sure that the link partner is set to auto-negotiate.

–Make sure that the switch is 802.3ab-compliant (gigabit over copper).

A wireless LAN problem

Problem: You cannot connect to the network using the built-in wireless networking card.

Solution: Make sure that your wireless LAN driver is the latest version. Check the Web site and confirm the driver version supported by Access Connections is the latest documented in the readme file.

Make sure that your computer is within range of a wireless access point.

Chapter 10. Troubleshooting computer problems 143