5.Slide the new optical drive into the drive bay from the front and align the screw holes in the new optical drive with the corresponding holes in the drive bay. Then, install the three screws to secure the new optical drive in place.

Figure 24. Installing the optical drive

6.Connect one end of the signal cable to the rear of the new optical drive and the other end to an available SATA connector on the system board. See “Locating parts on the system board” on page 13. Then, locate an available five-wire power connector and connect it to the rear of the new optical drive.

Figure 25. Connecting the optical drive

What to do next:

To work with another piece of hardware, go to the appropriate section.

To complete the installation or replacement, go to “Completing the parts replacement” on page 63.

46ThinkCentre User Guide

Page 58
Image 58
Lenovo 3484JMU manual Installing the optical drive