3.Locate the battery. See “Locating parts on the system board” on page 11.
4.Remove the old battery.
Figure 19. Removing the old battery
5. Install a new battery.
Figure 20. Installing a new battery
6.Reinstall the computer cover and connect the cables. See “Completing the parts replacement” on page 60.
Note: When the computer is turned on for the first time after replacing the battery, an error message might be displayed. This is normal after replacing the battery.
7.Turn on the computer and all attached devices.
8.Use the Setup Utility program to set the date, time, and any passwords. See Chapter 7 “Using the Setup Utility program” on page 71.
What to do next:
•To work with another piece of hardware, go to the appropriate section.
•To complete the installation or replacement, go to “Completing the parts replacement” on page 60.
Replacing the hard disk drive
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.
This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive, do the following:
1.Turn off the computer and disconnect all power cords from electrical outlets.
2.Remove the computer cover. See “Removing the computer cover” on page 32.
3.Remove the front bezel. See “Removing and reinstalling the front bezel” on page 32.
40ThinkCentre User Guide
