8.Position the new memory module over the memory slot. Make sure that the notch 1 on the memory module aligns correctly with the slot key 2 on the system board. Push the memory module straight down into the slot until the retaining clips close.
Figure 16. Installing a memory module
What to do next:
•To work with another piece of hardware, go to the appropriate section.
•To complete the installation or replacement, go to “Completing the parts replacement” on page 60.
Installing or replacing a PCI card
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.
This section provides instructions on how to install or replace a PCI card. Your computer has two PCI Express x1 card slot and one PCI Express x16 graphics card slot.
To install or replace a PCI card, do the following:
1.Turn off the computer and disconnect all power cords from electrical outlets.
2.Remove the computer cover. See “Removing the computer cover” on page 32.
3.Rotate the PCI card retainer to the open position.
4.Depending on whether you are installing or replacing a PCI card, do one of the following:
•If you are replacing an old PCI card, remove the screw that secures the old PCI card and release the old PCI card from the PCI card slot.
Chapter 5. Installing or replacing hardware 37
