Other Settings & Features
Auto Config/Update
The Auto Config/Update screen provides two (2) features:
•Auto Config - The Access Point will configure itself by copying data from another (compatible) Access Point.
•Auto Update - The Access Point will update it Firmware by downloading the Firmware file from your FTP Server.
Figure 54: Auto Config/Update Screen
Data - Auto Config/Update Screen
Admin Connections
Perform Auto | If checked, this AP will perform Auto Configuration the next |
Configuration on this AP | time it restarts. |
next restart | • The wired LAN (NOT the Wireless LAN) will be |
| |
| searched for compatible APs. |
| • If a compatible AP is found, its configuration is |
| copied. If more than one compatible AP exists, the |
| first one found is used. |
| • Some data cannot be copied: |
| o The IP address is not copied, and will not |
| change. |
| o The operating mode ( Repeater, Bridge, etc) |
| is not copied, and will not change. |
| Note: This checkbox is automatically disabled, so the Auto- |
| configuration is only performed once. |
|
|
71
