Introduction
Rear Panel
| Figure 3 Rear Panel |
Antenna | One antenna (aerial) is supplied. Best results are usually obtained with |
| the antenna in a vertical position. |
Console port | DB9 female RS232 port. |
Reset Button | This button has two (2) functions: |
| • Reboot. When pressed and released, the Wireless Access Point |
| will reboot (restart). |
| • Reset to Factory Defaults. This button can also be used to clear |
| ALL data and restore ALL settings to the factory default values. |
| To Clear All Data and restore the factory default values: |
| 1. Power Off the Access Point |
| 2. Hold the Reset Button down while you Power On the Access |
| Point. |
| 3. Continue holding the Reset Button until the Status (Red) LED |
| blinks TWICE. |
| 4. Release the Reset Button. |
| The factory default configuration has now been restored, and the |
| Access Point is ready for use. |
Ethernet | Use a standard LAN cable (RJ45 connectors) to connect this port to a |
| 10BaseT or 100BaseT hub on your LAN. |
Power port | Connect the supplied power adapter here. |
5
