Hide SSID | If “Hide SSID“ check box is enabled, the AP will not appear in the |
| site survey list of any wireless adapters. It means Only the |
| wireless adapters set the same SSID can connect to the AP. It |
| aviods the AP being connected by unauthorized users. |
Change/Apply | Clcik “Change“ will enable you to setup the parameters of |
| “General Connection Setting“. In the meantime, the button will |
| change to “Apply“ for you to confirm your settings. |
Authentication Mode | Open System – No authentication is needed for connecting to the |
| AP. |
| Shared Key – Only wireless adapters using a shared key (WEP Key |
| identified) are allowed to connecting to the AP. |
WEP | Enable or disable WEP encryption function. If the WEP function is |
| enabled, only wireless adapters with the same default key and |
| WEP key setting can connect to the AP. |
Setting | Click “Setting“ to setup the WEP key. Please refer to Section 5.3 |
| for more WEP key description. |
|
|
Parameter | Description |
|
|
Fragement | The value defines the maximum size of packets, any packet size |
| larger than the value will be fragmented. If you have decreased |
| this value and experience high packet error rates, you can |
| increase it again, but it will likely decrease overall network |
| performance. Select a setting within a range of 256 to 2346 bytes. |
| Minor change is recommended. |
RTS / CTS | Minimum packet size required for an RTS/CTS (Request To |
| Send/Clear to Send). For packets smaller than this threshold, an |
| RTS/CTS is not sent and the packet is transmitted directly to the |
| WLAN. Select a setting within a range of 0 to 2347 bytes. Minor |
| change is recommended. |
Preamble | The preamble defines the length of the CRC block for |
| communication among the wireless networks. There are two |
| modes including Long and Short. High network traffic areas |
| 31 |
