Lexicon Lexicon MC-12 manual Record Zone Two-Line Status, Status Menus, Two-Line Status from

Basic Operation

Lexicon

Two-Line Status (continued from page 2-19)

Record Zone Two-Line Status

Opens on the on-screen and front panel	DVD1	%!D VOL
displays whenever the MC-12 detects a	RECORD	-34dB
Record Zone status change. The Record Zone

two-line status indicates the current input, input source, and volume level selected in the Record Zone.

The ON-SCREEN DISPLAY menu STATUS parameter can be used to control the length of time for which the two-line status appears on the on-screen and front panel displays. The ON-SCREEN DISPLAY menu POSITION parameter can be used to control the vertical alignment of the two-line status on the display device screen.

Note:

On-screen display menus – including the two-line status – will not appear on the display device screen when the display device is connected to the component video output connector and the MAIN ADV menu COMPONENT OSD parameter is set to OFF.

STATUS MENUS

When the Shift command bank is activated, pressing the remote control STAT button opens the status menu for the current input source. Status menus are available for 2-channel, Dolby Digital, dts(-ES), analog, and digital sources. All status menus are shown at the top of the next page.

Status menu parameters provide information about the current input source and listening mode. Some status menus also include level meters that indicate fluctuating audio input levels. Refer to page 2-24 for status menu parameter descriptions.

Note:

Status menu parameters provide information about the current input source and listening mode. These parameters cannot be adjusted.

Unlike most other menus, status menus cannot be opened through the selection of menu options. Rather, the remote control command sequence outlined below must be used.

To open and navigate the status menu for the current input source:

1.Press and release the remote control SHIFT button to activate the Shift command bank.

2.Press and release the remote control STAT button. The first page of the status menu for the current input source will open on the on-screen and front panel displays. If the status menu includes a second page, the PG1 indicator appears in the top- right corner of the menu. Press the STAT button again to open the second page. If the status menu does not include a second

2-20