SETUP
MC-12
3-27
When a THX speaker setup is selected, the FRONT L/R parameter
cannot be adjusted. The MC-12 automatically applies a THX 80Hz
crossover point to the Front L/R output connectors.
CENTER FULL, 30 to 120Hz, THX 80Hz, NONE
Assigns a crossover point for the Main Zone audio output
connector labeled Center.
When a custom speaker setup is selected, the CENTER parameter
opens the CENTER SPEAKER menu shown on the previous page,
which can be used to select a crossover point for the Center output
connector.
• Select FULL to send a full-range signal to the center speaker.
Otherwise, select the crossover point closest to the low-
frequency rating of the center speaker.
• Select NONE if the speaker setup does not include a center
speaker. The MC-12 will redirect center channel signals to the
Front L/R output connectors – unless the 5.1a BYPASS listening
mode is activated. In this instance, configure the speaker setup
with the associated DVD-A/SACD player to redirect center
channel signals.
When a THX speaker setup is selected, the CENTER parameter
cannot be adjusted. The MC-12 automatically applies a THX 80Hz
crossover point to the Center output connector.
THX SETUPSET CROSSOVERSSPEAKERSSETUP
CENTERCUSTOM SETUPSET CROSSOVERSSPEAKERSSETUP
THX SETUPSET CROSSOVERSSPEAKERSSETUP SIDE L/R FULL, 30 to 120Hz, THX 80Hz, NONE
Assigns a crossover point for the Main Zone audio output
connectors labeled Side L/R.
When a custom speaker setup is selected, the SIDE L/R parameter
opens the SIDE L/R SPEAKERS menu shown on the previous page,
which can be used to select a crossover point for the Side L/R
output connectors.
• Select FULL to send a full-range signal to the side speakers.
Otherwise, select the crossover point closest to the low-
frequency rating of the side speakers.
• Select NONE if the speaker setup does not include side
speakers. The MC-12 will redirect side channel signals to the
Rear L/R output connectors. If the REAR L/R parameter is also
set to NONE, the MC-12 will redirect surround channel signals
to the Front L/R output connectors.
Note:
When the SIDE L/R parameter is set to NONE, Dolby
Digital Surround EX, THX Ultra2, THX Surround EX,
and dts-ES decoding are not available. The ASA
parameter is also not available.
When a THX speaker setup is selected, the SIDE L/R parameter
cannot be adjusted. The MC-12 automatically applies a THX 80Hz
crossover point to the Side L/R output connectors.
. . . Setting Crossover Points continues on page 3-28
THX SETUPSET CROSSOVERSSPEAKERSSETUP
SIDE L/RCUSTOM SETUPSET CROSSOVERSSPEAKERSSETUP