Lexmark 35S0150, 35S0200, MS410DN manual Run Initial setup, Paper Sizes, Timeouts

Understanding the printer menus		75
	Use	To
	Run Initial setup	Run the setup wizard.
	Yes	Notes:
	No
		• Yes is the factory default setting.
		• After completing the setup wizard by selecting Done at the
		country or region selection screen, the default becomes No.
	Paper Sizes	Specify the unit of measurement for paper sizes.
	US	Notes:
	Metric
		• US is the factory default setting.
		• The initial setting is determined by your country or region
		selection in the initial setup wizard.
	Timeouts	Set the amount of time the printer waits after a job is printed before
	Sleep Mode	it goes into a reduced power state.
	Disabled	Notes:
	1–120 min	• “30 min” is the factory default setting.
		• “Disabled” appears only when Energy Conserve is set to Off.
		• Lower settings conserve more energy, but may require
		longer warm‑up times.
		• Select a high setting if the printer is in constant use. Under
		most circumstances, this keeps the printer ready to print
		with minimum warm‑up time.
	Timeouts	Set the amount of time the printer waits before it enters Hibernate
	Hibernate Timeout	mode.
	Disabled	Notes:
	1 hour	• “Disabled” is the factory default setting in all countries
	2 hours
		except European Union countries and Switzerland.
	3 hours
		• “3 days” is the factory default setting for all European Union
	6 hours
		countries and Switzerland.
	1 day
	2 days
	3 days
	1 week
	2 weeks
	1 month
	Timeouts	Set the printer to Hibernate mode even if there is an active Ethernet
	Hibernate Timeout on Connection	connection.
	Hibernate	Note: “Do Not Hibernate” is the factory default setting.
	Do Not Hibernate
	Timeouts	Set the amount of time in seconds the printer waits before the it
	Screen Timeout	returns to a ready state.
	15–300 sec	Note: “30 sec” is the factory default setting.