Lexmark 35S0150, 35S0200, MS410DN manual Print Recovery

Understanding the printer menus		76
	Use	To
	Timeouts	Display a message that lets you reset the screen timeout timer
	Prolong Screen Timeout	instead of returning to the printer display.
	On	Note: Off is the factory default setting.
	Off
	Timeouts	Set the amount of time in seconds the printer waits to receive an
	Print Timeout	end‑of‑job message before canceling the remainder of the print
	Disabled	job.
	1–255 sec	Notes:
		• “90 sec” is the factory default setting.
		• When the timer expires, any partially printed page still in the
		printer is printed, and then the printer checks to see if any
		new print jobs are waiting.
		• Print Timeout is available only when using PCL emulation.
		This setting has no effect on PostScript emulation print jobs.
	Timeouts	Set the amount of time in seconds the printer waits for additional
	Wait Timeout	data before canceling a print job.
	Disabled	Note: “40 sec” is the factory default setting.
	15–65535 sec
	Print Recovery	Let the printer automatically continue printing from certain offline
	Auto Continue	situations when these are not resolved within the specified time
	Disabled	period.
	5–255 sec	Note: Disabled is the factory default setting.
	Print Recovery	Specify whether the printer reprints jammed pages.
	Jam Recovery	Notes:
	On
		• Auto is the factory default setting. The printer reprints
	Off
		jammed pages unless the memory required to hold the
	Auto
		pages is needed for other printer tasks.
		• On sets the printer to always reprint jammed pages.
		• Off sets the printer to never reprint jammed pages.
	Print Recovery	Notes:
	Jam Assist	• On is the factory default setting. On sets the printer to
	On
		automatically dump blank pages or partially printed pages to
	Off
		the standard bin after a jammed page has been cleared.
		• Off requires the user to remove all pages from all possible
		jam locations.
	Print Recovery	Successfully print a page that may not have printed otherwise.
	Page Protect	Notes:
	Off
		• Off is the factory default setting. Off prints a partial page
	On
		when there is not enough memory to print the whole page.
		• On sets the printer to process the whole page so that the
		entire page prints.