LG Electronics 26LD343H, 42LD343H, 37LD343H, 32LD343H, 32LD333H TLL-1100A Cloning Notes, Or Catv

Cloning Procedures (Cont.)

Learning / Teaching a Master TV Setup using a TLL-1100A Clone Programmer

Warning: Do not connect a clone programmer to a PPV card installed in the Master or Target TVs. Also, if the TV is in LodgeNet PPV Mode (check with the site administrator if you are not certain), do not connect a clone programmer to the GAME CONTROL/MPI port. Either of these actions will damage the clone programmer and, if applicable, the PPV card.

Cloning is accomplished using the TV/ clone programmer MPI ports for com- munication (see figure).

TLL-1100A Cloning Notes

•Read the IMPORTANT CLONING INFORMATION on page 27 before beginning any cloning procedures.

•Ensure the TLL-1100A is either fully charged or connected to AC power.

•Learning and Teaching is only possible between identical model TVs; however, the TLL-1100A clone programmer can store up to eight different Master TV Setups.

Learn Setup from Master TV

Antenna

or CATV

CLONE SELECTION MENU

Selected Bank: CBankX Saved

(1)LEARN FROM TV

(2)TEACH TO TV

(3)SET CLONE CLOCK FROM TV

(4)SET TV CLOCK FROM CLONE

(5)DISPLAY TV SETUP

(6)DISPLAY CLONE SETUP

TLL-1100A Clone

Programmer TV Link	CHARGE
Loader

TLL1100A
Ready
MODE	MENU
MPI	ENTER
Cable
RECEIVE	SEND

TLL-1100A

1.Ensure the Master TV is set up completely and the EBL is in Pass- through Mode.

2.If an analog channel is not available, direct tune the TV to an Aux source, or select an Aux source, such as AV-1, from the Input Menu. Then, plug one end of the MPI cable into the TV MPI port.

3.Turn ON the TLL-1100A.

4.Use the MODE button on the TLL-1100A to select Clone Mode.

5.Use the Left/Right arrows on the TLL-1100A to select the Memory CBank (1 to 8) in which to store the Master TV Setup.

6.Plug the other end of the MPI cable into the MPI port on the bottom of the TLL-1100A. The Clone Selection Menu will display on the TV screen.

7.Press 1 on the Installer Remote to select LEARN FROM TV from the Clone Selection Menu. Then, press ENTER to transfer the Master TV Setup into CBankX on the TLL-1100A.

Learning usually takes about 90 seconds. “LEARNING IN PROGRESS” will be displayed on the screen while the TLL-1100A copies the Master Setup. When the Learning process is complete, a “LEARNING COM- PLETE” message will be displayed.

CLONE SELECTION MENU Selected Bank: CBankX Saved

(1)LEARN FROM TV

(2)TEACH TO TV

(3)SET CLONE CLOCK FROM TV

(4)SET TV CLOCK FROM CLONE

(5)DISPLAY TV SETUP

(6)DISPLAY CLONE SETUP

CLONE CLOCK = XX:XX

TV CLOCK = XX:XX

THE CLONE IS VERSION VX.X.X

-To change menu items, press channel keys or digits.

-To execute item, press Enter.

206-4163 29