LG Electronics 37LD333H, 42LD343H, 37LD343H, 26LD343H, 32LD343H Clone Programmer Troubleshooting

Troubleshooting (Cont.)

Clone Programmer Troubleshooting

Warning: Do not connect a clone programmer to a

PPV card installed in the Master or Target TVs, as this will damage the clone programmer and the PPV card.

Reset Clone Programmer After Static Shock

After replacing exhausted batteries (LT2002 only), or if the clone programmer behaves strangely after a static shock:

•TLL-1100A: Turn the TLL-1100A OFF and then ON.

•LT2002: Use a paper clip or similar instrument inserted through the small hole marked RESET to activate the internal reset switch and restore normal operation.

After a reset, check the real-time clock setting. It may be necessary to set the clone programmer clock from a TV containing the correct time.

Notes

•The TLL-1100A and LT2002 clone programmers are designed to be used with TVs containing the 221- 01006 and later processors. Use with earlier TVs may give unpredictable results. Processors used before the 221-01006-04 have a limited screen display ca- pability; they cannot display entire screens as shown in the setup instructions accompanying the clone programmer. Use the printed menu illustrations in the documentation as an aid to making your programming choices.

•The Master and Target TVs must be in Pass-through Mode for cloning purposes. See also IMPORTANT CLONING INFORMATION on page 23.

Symptom Possible Cause(s) Possible Solution(s)

Clone Programmer

Clone copies setup in less than 30 seconds.

Not enough time to copy entire TV setup.

TLL-1100A: Turn the TLL-1100A Off and then ON.

LT2002: Press RESET on clone programmer.

Then redo Learn/Teach. (Learning usually takes about 90 seconds; Teaching usually takes 3 to 4 minutes.)

Remote does not operate clone programmer.

Clone menu does not dis- play on TV screen, TLL- 1100A shows error mes- sage, or LT2002 LED does not blink.

Clone menu hard to read. No time set.

Clone not working.

Clone scans channels more than once.

Wrong Installer Remote.

MPI cord not connected. TV not turned ON.

(LT2002 only) Weak batteries. (TLL-1100A only) No charge. Weak signal.

Time not available.

Clone programmer problem.

Clone should only scan channels once.

Only use an LG Installer Remote to operate clone programmer with TV.

Connect MPI cord properly, and ensure good connection. TV must be powered ON for clone programmer to work. Install four (4) fresh AA high-quality alkaline batteries.

Ensure the TLL-1100A is fully charged or connected to AC power. Connect TV to a reliable analog channel signal source.

Set time on a TV, and copy time to clone programmer.

•Try a different clone programmer.

•Reset the clone programmer.

Ensure TV is set up correctly, and try cloning again.

Master and Target TVs

Cloning did not work.	Procedure interrupted.	Wait until procedure complete message is displayed.
	Different TV models.	Cloning is only possible with identical model TVs.
	Step(s) omitted or not per-	Refer to the applicable cloning procedure(s), and make sure all
	formed.	tasks were performed.
(LT2002 only) Clone time	Batteries were removed.	Batteries must remain installed to retain time settings.
disappeared.
New setup not present.	Target TV not reset.	Disconnect Target TV from AC power for fifteen (15) seconds.

•After cloning operations are complete, unplug the TLL-1100A/LT2002 from the TV.

•If the TV does not display a picture (blank screen) after a few seconds, just change channels.

206-4177 45