LG Electronics 42LS75A 49LS75A 55LS75A owner manual Picture ID Settings

32ENTERTAINMENT

ENGLISH

PICTURE ID Settings

PICTURE ID is used to change the settings of a specific set (display) using a single IR receiver for multi-vision. Communication is possible between a monitor with an IR receiver and other monitors using RS-232C cables. Each monitor is identified by a Set ID. If you assign the PICTURE ID using the remote control, only displays with matching PICTURE ID and Set ID can be controlled remotely.

1Assign the Set ID to the installed monitors as shown below.

IR & Light Sensor

RS-232C cables

PICTURE ID ON [2]

3Assign the Set ID to the selection of your choice.

••A set with a different Set ID from the PICTURE ID cannot be controlled by IR signals.

NOTE

••If PICTURE ID is set to 2, only the upper right monitor, which has a Set ID of 2, can be controlled by IR signals.

••If you press the green OFF button for PICTURE ID, the PICTURE IDs for all monitors are turned off. If you then press any button on the remote control, all monitors can be controlled by IR signals regardless of Set ID.

••With PICTURE ID ON, you can only increase the PICTURE ID by 1. You cannot decrease it.

2Press the red ON button on the remote control to assign the PICTURE ID.