LG Electronics IP LDK-20 Entering programming mode, Permanent Update Procedure, Enter PGM Number

IPLDK-20 Installation Manual Starting the IP LDK-20 System

6.2.2 Entering programming mode

To enter Programming Mode, perform the following Steps:

Lift the handset

OR

Press the [MON] button on the ADMIN station, and hear ICM dial tone.

1.Press the [TRANS/PGM] button and dial ＊# .

2.Confirmation tone should be heard.

3.Enter the ADMIN password if the password has been set.

4.A confirmation tone should be heard indicating that the station is in ADMIN Programming mode.

5.Each program is accessed by pressing the [TRANS/PGM] button, the following should display:

ENTER PGM NUMBER

6.Dial the desired three-digit program number. If an error is made while entering data, the [TRANS/PGM] button will return to the previous status.

※NOTE

To return to the parent state while ADMIN programming, press the [CONF] button. Pressing the [CONF] button clears temporary data fields.

6.2.2.1 Permanent Update Procedure

To accept changes while programming, perform the following Steps:

1. Press the [HOLD/SAVE] button when all changes have been entered to store the data permanently.

A confirmation tone should be heard when pressing the [HOLD/SAVE] button if all data was entered correctly. If there were any errors in the entry, then an error tone is presented and data is not stored in the permanent memory.

6.2.2.2 Resetting the System

To reset the system, perform the following Steps:

1. Enter [PGM] + 450 then [FLEX] + 15 and press the [HOLD/SAVE] button.

OR

Press [PGM] + 100 then [FLEX] + 1 (Nation Code Assign) to automatically reset the system.

67