Life Fitness 849 manual ING Bolt

		FIGURE 34		STEP 34:
				• Route the threaded end of the PRESS
					CABLE (44) around one 4-1/2” PULLEY
	82				(48) and SECURELY assemble the pulley
					to the front slot of the PRESS ARM AD-
					JUST (36) using one 3/8 X 2-3/4” BOLT
36	69				(90), two 3/8” FLANGE SPACERS (69),
					and one 3/8” LOCK NUT (82) as shown in
					FIGURE 34. (NOTE: Loop the cable over
					the pulley prior to inserting it into the
	69	116	82		slot.)
				• Route PRESS CABLE (44) through the slot in
	58
					the PRESS BASE (38) then SECURELY as-
					semble one 4-1/2” PULLEY (48) to the
90 3/8 X 2-3/4”					PRESS BASE (38) using two 3/8 X 4”
					BOLTS (92), two 2-7/8 X 2-1/4” CABLE
		80			CLIPS (116), two 3/8” FLANGE SPACERS
					(69), two 3/8 X 1/2” SPACERS (58), two 3/
			44		8” WASHERS (80), and two 3/8” LOCK
					NUTS (82) as shown in FIGURE 34.
					(NOTE:Make sure the cable is routed be-
92 3/8 X 4”					tween the pulley and the CABLE RETAIN-
					ING BOLT.)
	48
				•	Route the PRESS CABLE (44) around one
	38
					4-1/2” PULLEY (48) and SECURELY as-
92 3/8 X 4”					semble the pulley to the rear slot of the
					PRESS ARM ADJUST (36) using one 3/8
					X 2-3/4” BOLT (90), two 3/8” FLANGE
					SPACERS (69), and one 3/8” LOCK NUT
					(82) as shown in FIGURE 34. (NOTE:
					Loop the cable over the pulley prior to
					inserting it into the slot.)

STEP 35:
• SECURE the PRESS CABLE (44) and two 4-1/2”			89 3/8 X 2”	80
PULLEYS (48) to the vertical flats on the PRESS BASE
(38) and on the PRESS WEIGHT STACK BASE (24)			24
using two 3/8 X 2” BOLTS (89), two 2-7/8” CABLE
CLIPS (67) two 3/8” WASHERS (80), and two 3/8”
LOCK NUTS (82) as shown in FIGURE 35. (NOTE:
The PRESS CABLE (44) should be routed
underneath the short leg of the CABLE CLIP. Also,
the CABLE CLIPS should be positioned straight
down to function properly.)
						82
			44 PRESS	48
				67		38
			CABLE
		FIGURE 35
1/2	1/2	1/2	1/2	1/2	5	1/2
0	1	2	3	4		6
			28