FIGURE 42 |
LEG CABLE 43 |
50 |
53 |
STEP 42:
•Screw the threaded end of the LEG CABLE (43) approximately 1” into the end of the SELECTOR SHAFT (50) of the HEAD PLATE (53) as shown in FIGURE 42.
STEP 43: | 53 |
• Perform the following to all three WEGHT STACKS: | |
• Insert one WEIGHT STACK PIN (75) into each weight stack on the 8500 | 106 |
GYM as shown in FIGURE 43. |
|
• If upon completion of assembly, the HEAD PLATE (53) does not sit on top |
|
of the first WEIGHT PLATE (106), push the HEAD PLATE (53) down, |
|
insert the WEIGHT STACK PIN (75) and perform several repetitions at the |
|
press station. This will relax the cable system and prevent the HEAD |
|
PLATE (53) from lifting up. |
|
• If after completing previous step, the HEAD PLATE (53) still does not sit |
|
on top of the first WEIGHT PLATE (106) or if there is excess slack in the | 75 |
cable system, adjust the threaded end of the CABLE accordingly and |
|
retighten the jam nuts. |
|
• If there is excess slack in the AB or PEC DEC cable system, adjust the |
|
threaded end of the AB CABLE (45) accordingly and retighten the jam |
|
nut. |
|
| FIGURE 43 |
33 |
|
