ConsoleServer 3200 System

Lightwave Communications

CONNECTIONS command is used alone. (See section 6.8, Sys Admin Session Management Commands).

The CONNECTIONS command will also tell the sys admin which terminal ports are present (in the list, they are referred to as "channels"). If the port is not functioning (i.e., the card is not present or there is a fault with the individual port), the port will be listed as "<not installed>". It will also list Telnet Active for an active Telnet session.

7.9.2 LISTCARDS Command

Sys admin>>LISTCARDS

Installed cards

Slot A : <card not installed>

Slot B : Terminal card installed

Slot C : Terminal card installed

Slot D : Terminal card installed

Slot E : Terminal card installed

Slot F : Switch card 1 installed

Slot G : Switch card 2 installed

Slot H : Device card installed

Slot I : Device card installed

Slot J : Device card installed

Slot K : Device card installed

Slot L : Device card installed

Slot M : Device card installed

Slot N : Device card installed

Slot O : Device card installed

sys admin>>

The LISTCARDS command will simply tell the sys admin which cards are plugged into the SCS3230 chassis. It only lists the cards (by type) as present or not present, and does not indicate whether the cards are functioning properly.

7.9.3 VERSION Command

sys admin>>VERSION /ALL SCS3230

Slot B1: V2.15 10/01/99 Terminal Boot V1.62 (Sep 30 1999) (14:33:12)

Slot C1: V2.15n 10/01/99 Net Terminal Boot V1.62 (Sep 30 1999) (12:44:32)

Slot C2: V1.16 Build 7 09/29/99 Network Boot V1.62 (Sep 30 1999) (14:45:52) Ethernet Address: 00-30-31-00-01-D5

Slot F1: V 1.03 Switch 1

Slot G1: V 1.03 Switch 2

Slot H1: V2.15 10/04/99 Device Boot V1.62 (Sep 30 1999) (14:40:51)

Slot P1: V2.12 Build 15 10/01/99 Control Boot V1.62 (Oct 01 1999) (11:13:06)

sys admin>>

By itself, the VERSION command lists the boot and flash software version for the control card. The version information for a single card other than the control card may be displayed by typing the card slot letter ID after the VERSION command. If the sys admin

Rev. A

- 68 -

www.lightwavecom.com

Page 68
Image 68
Lightwave Communications SCS3230 manual Listcards Command, Version Command