Lincoln Electric IM10023 manual Parameter Definition 101 View Event Logs, View Fatal Logs

B-12		OPERATION	B-12
		USER DEFINED PARAMETERS (CONT.)
	Parameter	Definition
	P.101	View Event Logs

Used for viewing all the system event logs. Press the Right Button to enter the option. Rotate Control Knob to select the desired event log to read. Press the Right Button again to enter the selected log. Rotating the Control Knob will scroll through the event log, displaying the log index number, event code and some other data. Press the Left Button to back out to select another log. Press the Left Button again to exit this option.

P.102	View Fatal Logs
	Used for viewing all the system fatal logs. Press the Right Button to enter the option. Rotate
	Control Knob to select the desired fatal log to read. Press the Right Button again to enter that
	log. Rotating the Control Knob will scroll through the log, displaying the log index number and
	fatal code. Press the Left Button to back out to select another log. Press the Left Button again to
	exit this option.

P.103	View Software Version Information
	Used for viewing the software versions for each board in the system. Press the Right Button to
	enter the option. Rotate Control Knob to select the desired board to read. Press the Right
	Button again to read the firmware version. Press the Left Button to back out to select another
	board. Rotate the Control Knob to select another board, or press the Left Button to exit this
	option.

P.104	View Hardware Version Information
	Used for viewing the hardware version for each board in the system. Press the Right Button to
	enter the option. Rotate Control Knob to select the desired board to read. Press the Right
	Button again to read the hardware version. Press the Left Button to back out to select another
	board. Press the Left Button again to exit this option.

P.105	View Welding Software Information
	Used for viewing the Weld Set in the Power Source. Press the Right Button to read the Weld
	Set version. Press the Left Button to back out and exit this option.
P.106	View Ethernet IP Address
	Used for viewing the IP address of Ethernet compatible equipment. Press the Right Button to
	read the IP Address. Press the Left Button to back out and exit this option. The IP address can-
	not be changed using this option.
P.107	View Power Source Protocol
	Used for viewing the type of power source the feeder is connected to. Press the Right Button to
	identify the power source as either LincNet or ArcLink. Press the Left Button to back out and exit
	this option.
P.501	Encoder Lockout
	Locks one or both of the upper knobs (encoders), preventing the operator from changing wire
	feed speed, amps, volts or trim. The function of each upper knob depends on the selected weld
	mode. When a constant current weld mode is selected (e.g. Stick, TIG, Gouge), the upper right
	knob will always function as an on/off switch. This parameter can only be accessed using Power
	Wave.

MAXsa™ 10 CONTROLLER