Figure 82: Connecting the HP AC Power Adapter’s Cable to the Camera
Note: Use the
Using the HP AC Power Adapter
To connect the HP AC Power Adapter to the camera:
1Plug the AC power adapter into a power source, such as a wall outlet or power strip.
2Open the door to the connector compartment on the camera. The connector compartment is located on the far right side of the camera when you are looking at the front of the camera.
3Connect the round end of the AC power adapter’s cable to the middle (power adapter) connector in the camera (see Figure 82).
Using the HP NiMH Batteries and Recharger
If you purchase the HP NiMH Battery Recharger, which includes 4 rechargeable NiMH batteries, please note the following:
Before you install the batteries in the HP 618 camera, you must charge all 4 NiMH batteries in the HP NiMH Battery Recharger per the instructions that came with the Battery Recharger.
You must recharge all 4 NiMH batteries after fully draining them four times for the batteries to reach their optimum capacity and performance.
Always recharge all 4 NiMH batteries at the same time. One
Do not store the batteries in the HP NiMH Battery Recharger for an extended period of time if it is not necessary.
Do not
Do not expose the NiMH batteries to heat. Permanent damage will result if the batteries are exposed to temperatures above 110° F or 43° C. Always store the batteries in a cool location.
After
Appendix B: Camera and Accessories Information | 108 | HP Accessories for Powering the Camera |
|
|
|