HP 618 manual Transmitting Images Between Two Cameras, Sending Images to Another Camera

Transmitting Images Between Two Cameras

You can use the Camera-Camera option in the Transmit menu of Review mode to send images from your camera to another camera, or to receive images from another camera. The other camera must use the standard Digita transmit protocol. See the other camera’s documentation for details.

Sending Images to Another Camera

To send the current image or all marked images to another Digita camera:

1Set the camera mode dial to Review mode .

2Power on the camera if you haven’t already.

3Either select one image or mark multiple images in the Review mode screen that you want to send to the other camera. (See “Selecting Images” on page 30 and “Marking and Unmarking Images” on page 31 for more information.)

4Press the MENU button on the back of the camera. The Review mode menus are displayed.

5Press the right arrow on the 4-way controller two times to move to the Transmit menu. The Camera-Camera menu option is highlighted.

6Press the left (Send) soft key on your camera. Your camera’s image LCD reads: “Receiving Camera Ready?”

7Set the other camera to receive images. See the other camera’s documentation for details.

8Aim your camera’s infrared window (see Figure 26 on page 46) at the other camera’s infrared sensor, and set the cameras about 10 inches apart.

9Press the left (Continue) soft key on your camera. Your camera immediately searches for another compatible camera and begins to transmit images to the other camera.

During the transfer, the image LCD reads: “Sending X image(s)...” and shows a progress bar. You can cancel the transfer at any time by pressing the middle (Stop) soft key on your camera. A confirmation screen will display to show that the transfer was successful.

10 Press the right (Done) soft key when you have finished transmitting images to the other camera.

Chapter 5: Sharing Images 48 Transmitting Images Between Two Cameras