OPTIONAL FIELD INSTALLED ACCESSORIES
K802R POWER PLUG KIT - Provides a plug for each receptacle.
K857 28 ft. (8.5 m) or K857-1 100 ft. (30.4 m) REMOTE CONTROL - Portable control provides same dial range as the output control on the welder from a location up to the specified length from the welder. Has convenient plug for easy connection to the welder. The Commander 400 is equipped with a 6 pin connector for connecting the remote control and a toggle switch for selecting “LOCAL” output control or “REMOTE” out- put control.
K704 ACCESSORY SET - Includes 35 feet (10 m) of electrode cable and 30 feet (9 m) of work cable, head- shield, work clamp and electrode holder. Cable is rated at 500 amps, 60% duty cycle.
K953-1 TWO WHEEL TRAILER - For road, in-plant and yard towing. Road towing with optional fender & light kit. (For highway use, consult applicable federal, state and local laws regarding possible additional requirements)
K953-1 Trailer
K958-1 Ball Hitch
K958-2 Lunette Eye Hitch
K959-1 Fender & Light Kit
K965-1 Cable Storage Rack
K825-1 ETHER START KIT - Provides maximum cold weather starting assistance for frequent starting below
10F (-12.2oC). Required Ether tank is not provided with kit.
K899-1 SPARK ARRESTOR KIT - Easily mounts to standard muffler.
K949-1 OIL DRAIN KIT - Includes ball valve, hose and clamp.
RECOMMENDED EQUIPMENT
STICK
K704 Accessory Kit which includes:
•Electrode holder and cable.
•Ground clamp and cable.
•Headshield.
K857 Remote Control Kit is optional for remote cur- rent control.
TIG
Magnum TIG Torch
Magnum Parts Kit and Argon gas
K930-1 TIG Module (not required for scratch start DC TIG welding)
K936-3 Control Cable
K870 Foot Amptrol
Also available:
K812 Hand Amptrol
K814 Arc Start Switch
K937-22 Control Cable Extension
K937-45 Control Cable Extension
K844-1 Water Valve
HIGH FREQUENCY GENERATORS FOR TIG APPLICATIONS
The K799 Hi-Freq Unit and the K930-1 TIG Module are suitable for use with the Commander 400. The Commander is equipped with the required R.F. bypass circuitry for the connection of high frequency generat- ing equipment. The high frequency bypass network supplied with the K799 Hi-Freq Unit does NOT need to be installed into the Commander.
The Commander and any high frequency generating equipment must be properly grounded. See the K799 Hi-Freq Unit and the K930-1 TIG Module operating manuals for complete instructions on installation, oper- ation, and maintenance.
