Lincoln Electric IM544-B manual LN-7 Connection Diagram

COMMANDER 400 STICK & WIRE /	K867 /	K775 /	LN-7 CONNECTION DIAGRAM
	WARNING
Do not operate with panels open.			Keep guards in place.
Disconnect NEGATIVE (-) BATTERY LEAD			Keep away from moving parts.
before servicing.			Only qualified personnel should install,use
Do not touch electrically live parts.			or service this equipment.

CONNECTION	F-8
DIAGRAM:

COMMANDER 400

14	PIN
AMPHENOL
TO	WORK	ELECTRODE
		TO WORK

CAUTION :

K867 UNIVERSAL

ADAPTER PLUG

ELECTRODE CABLE TO WIRE FEED UNIT

SPARE 82 81 42 41

31

32

2

4

21 GND

75

76

77

}N.D.

31

32

2

4

21 GND

GREEN

	75
	76
}	77

N.E.

LN-7

WIRE

FEEDER

K291 OR K404

INPUT CABLE

K775 OPTIONAL REMOTE CONTROL

DIAGRAMS

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN

THE ENGINE WELDER OPERATING MANUAL.

N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE APPILICATIONS. SEE OPERATING MANUAL.

N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE "RANGE" SWITCH TO "WIRE WELDING CV". PLACE WIRE FEEDER SWITCH TO "WIRE FEEDER WITH CONTROL CABLE POSITION.

N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL / REMOTE SWITCH IN "REMOTE" POSITION. N.D. INSULATE EACH UNUSED LEAD INDIVIDUALLY.

N.E. SPLICE LEADS AND INSULATE.

13-13-96

S22915

F-8