Lincoln Electric IM544-B manual Commander 400 Stick & Wire / K867 / LN-8 Connection Diagram

COMMANDER 400 STICK & WIRE / K867 / LN-8 CONNECTION DIAGRAM
WARNING
Do not operate with panels open.	Keep guards in place.
Disconnect NEGATIVE (-) BATTERY LEAD	Keep away from moving parts.
before servicing.	Only qualified personnel should install,use
Do not touch electrically live parts.	or service this equipment.

CONNECTION	F-6
DIAGRAM:

COMMANDER 400

14PIN

AMPHENOL

TO WORK ELECTRODE

TO WORK

CAUTION :

K867 UNIVERSAL

ADAPTER PLUG

ELECTRODE CABLE

TO WIRE FEED UNIT

SPARE
82
81	N.C.
42
41
31	31
32	32
2	2
4	4
21	21
GND	GND
75	A
76	B
77	C

N.D.

LN-8

WIRE

FEEDER

K196

INPUT CABLE

DIAGRAMS

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN

THE ENGINE WELDER OPERATING MANUAL.

N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE APPICATIONS. SEE OPERATING MANUAL.

N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO "WIRE WELDING CV". PLACE LOCAL / REMOTE SWITCH IN "REMOTE" POSITION.

N.C. INSULATE EACH UNUSED LEAD INDIVIDUALLY.

N.D. SPLICE LEADS AND INSULATE.

12-13-96

S22913

F-6