Lincoln Electric IM544-B manual Electrode Cable

COMMANDER 400

COMMANDER 400 STICK & WIRE TO K867 ADAPTER CONNECTION DIAGRAM

WARNING

Do not operate with panels open.	Keep	guards in	place.
Disconnect NEGATIVE (-) BATTERY LEAD	Keep	away from	moving parts.
before servicing.	Only qualified personnel should install,use
Do not touch electrically live parts.	or service this equipment.

14 PIN

AMPHENOL					N.C.
		81
		82	NOT USED ON	COMMANDER 400 POWER SOURCES
		SPARE			N.D.
	K867 UNIVERSAL	2	CONNECT TOGETHER FOR WELDING OUTPUT
	ADAPTER PLUG	4			N.C.
		41	NOT USED ON	COMMANDER 400 POWER SOURCES
		42
				N.E.
		31
			115 VAC
		32
TO WORK	ELECTRODE
		GND	POWER SOURCE FRAME CONNECTION
		21	WIRE FEEDER VOLTMETER CONNECTION
	ELECTRODE CABLE		CONNECTS TO (WORK TERMINAL) OF POWER SOURCE
	TO WIRE FEED UNIT	77	10K
	TO WORK	76	REMOTE OUTPUT CONTROL
		75	MIN.

CAUTION :

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE

AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE

DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN

THE ENGINE WELDER OPERATING MANUAL.

N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE

APPLICATIONS. SEE OPERATING MANUAL.

N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY.
N.C.	INSULATE EACH UNUSED LEAD INDIVIDUALLY.		2	TO
N.D.	FOR WIRE FEEDERS THAT RETURN A SIGNAL FOR WELDING OUTPUT, USE ISOLATION	TO		WIRE
	RELAY TO CLOSE LEADS 2 & 4.	K867		FEEDER
			4
N.E.	REFER TO POWER SOURCE INSTRUCTION MANUAL FOR MAXIMUM AUXILIARY CURRENT DRAW.

CONNECTION	F-9
DIAGRAM:

DIAGRAMS

6-12-98

S22916

F-9