Lincoln Electric IM613-B manual Setting DIP Switches in the Wire Drive, Figure A.4

A-7 INSTALLATION A-7

S2 DIP Switch Bank on Control Box Motherboard (For software version S24456-1)

Switch	Off		On
1	Network Group ID, MSB	(Assigns Control Box to a specific group) (Off is factory setting)
2	Network Group ID, LSB	(Assigns Control Box to a specific group ) (Off is factory setting)
3	4-Step Domestic Configuration		4-Step European Configuration
4	Power Feed 10 / Dual		Power Feed 11
5	Procedure change with trigger “OFF”		Procedure change with trigger “ON”
6	Must be off for normal operation		Adjust lower limits
7	Must be off for normal operation		Adjust upper limits
8	Must be on for all units (Permits selection of extended modes)

Note: the factory shipped settings for Switch S2 are as follows:
PF-11	European - Switches 1,2		& 5-7 “OFF”;	Switches 3,4,8 “ON”
PF-11	World	- Switches 1-3	& 5-7 “OFF”;	Switches 4, 8 “ON”

SETTING DIP SWITCHES IN THE WIRE
DRIVE	FIGURE A.4
There is one DIP switch bank on the control board of
the wire drive. It’s labeled S1 and is located and ori-
ented as shown in Figure A.4.	S1

O N 1 2 3 4 5 6 7

8

S1 DIP Switch Bank on Wire Drive Control Board (For software version S24468-1)

Switch	Off			On
1	Network Group ID, MSB	(Assigns Wire Drive to a specific group)
2	Network Group ID, LSB	(Assigns Wire Drive to a specific group )
3	Network Feed Head ID, MSB		(Assigns feed head number to wire drive)
4	Network Feed Head ID		(Assigns feed head number to wire drive)
5	Network Feed Head ID, LSB		(Assigns feed head number to wire drive)
6	Spare
7	Electrode Sense Polarity = Positive			Electrode Sense Polarity = Negative

Switch position must match polarity of weld cable attached to feed plate.

8

Gear Box Ratio = Low

Gear Box Ratio = High

Switch position must match actual gear box ratio of wire drive.

Note: the factory shipped settings for Switches 1-7 is “OFF”, Switch 8 is “ON”.

POWER FEED 11