INSTALLATION |
| |||
QUICK DISCONNECT PLUG (FOR STICK ELEC- | SHIELDING GAS CONNECTION |
| ||
TRODE CABLE and WORK CABLE) | Obtain the necessary inert shielding gas. Connect the | |||
A quick disconnect system is used for the welding | cylinder of gas with a pressure regulator and flow | |||
cable connections. The stick electrode cable will need | gage. Install a gas hose between the regulator and | |||
to have a plug attached. |
| gas inlet (located on the rear of the welder). The gas | ||
1. Cut off welding cable lug, if present. | inlet has a | |||
#032. | WARNING |
| ||
tion. |
|
|
| |
2. Remove 1.00 in. (25mm) of welding cable insula- |
| CYLINDER could explode |
| |
may be trimmed to match the cable diameter. Use |
|
| ||
| if damaged. |
| ||
3. Slide rubber boot onto cable end. The boot end |
| • Keep cylinder upright | and | |
soap or other |
| |||
help slide the boot over the cable, if needed. |
| chained to a support. |
| |
WELDING CABLE | BOOT | • Keep cylinder away from areas where it | ||
|
| could be damaged. |
| |
1.00 in. | TRIM, IF REQ'D | • Never allow the torch or welding electrode | ||
25 mm | TO FIT OVER CABLE | to touch the cylinder. |
| |
4. Insert copper strands into ferrule. | • Keep cylinder away from live electrical cir- | |||
cuits. |
|
| ||
| COPPER FERRULE | ___________________________________________ | ||
WELDING CABLE | REMOTE CONTROL CONNECTION |
| ||
|
| |||
|
| A remote control receptacle is provided on the lower | ||
5. Slide the copper ferrule into the brass plug. | center case front of the welder for connecting a | |||
remote control to the machine. Refer to the Optional | ||||
6. Tighten set screw to collapse copper tube. Screw | Accessories section of this manual for available | |||
remote controls. |
| |||
must apply pressure against welding cable. The |
|
|
| |
top of the set screw will be well below the surface |
|
|
| |
of the brass plug after tightening. |
|
|
| |
SET SCREW
COPPER TUBE | BRASS PLUG |
|
7.Slide rubber boot over brass plug. The rubber boot must be positioned to completely cover all electri- cal surfaces after the plug is locked into the recep- tacle.
