User Options
Table of user options
The following table shows the user options that are available, briefly describes them and shows the available settings for each. Default settings are shown in bold.
Option/Name | Description | Settings |
|
|
|
Set display brightness | Allows adjustment to brightness of front panel display. If default is not used then brightness is in the range | 50% |
| 6% to 100% | 6% - 100% |
|
|
|
Enable source memory | On: Each source has its own volume, bass, treble, balance and fader settings. | On |
| Off: All the sources use the same volume, bass, treble, balance and fader settings. | Off |
|
|
|
Enable IR sensor | Enables/disables control of the unit from the handset. | On |
|
| Off |
|
|
|
Set IR modulation: IR out 1 | Modulation frequency for infrared flasher 1. If default is not used then the frequency is in the range | 36 kHz |
| 1 to 576 kHz | 1 to 576 kHz |
|
|
|
Set IR modulation: IR out 2 | Modulation frequency for infrared flasher 2. If default is not used then the frequency is in the range | 56 kHz |
| 10 to 2304 kHz | 10 to 2304 kHz |
|
|
|
Configure ACC socket | Defines the use of the accessory socket (ACC). IR = infrared repeater | IR |
| RCU = KNEKT remote control unit | RCU |
|
|
|
Configure Knekt mode | Auto: Determines whether the unit is being used in a CONNECT or KNEKT system. | Auto |
| Main: See KNEKT documentation. | Main |
| Room: See KNEKT documentation. | Room |
|
|
|
46
