Lochinvar 50-210 service manual Parameter table continued, Service Manual

Service Manual

1Service

Parameter table (continued)

Table 1D (continued from previous page) This table lists SMART SYSTEM control module parameters and where to access them

ANTI-CYCLING

MENU	SUB ITEM	DESCRIPTION	SEE	USER ACCESS		INSTALLER ACCESS
			PAGE	DISPLAY	MODIFY	DISPLAY	MODIFY
	1	Anti-cycling Time	20	No	No	Yes	Yes
G	2	Return Temperature Differential for	20	No	No	Yes	Yes
		Ending Anti-Cycling
	3	Ramp Delay On/Off	20	No	No	Yes	Yes

CONTROL

CIRCULATION

SERVICE

		1	SH Controlling Sensor	21	No	No	Yes	Yes
			(Outlet/System, Inlet)
MODES	H	2	SH Source (Thermostat, BMS, and	21	No	No	Yes	Yes
			Cascade)
		3	Boiler Cascade Address	21	No	No	Yes	Yes
		4	Max. Cascade Set Point	21	No	No	Yes	Yes
		5	Cascade Offset	22	No	No	Yes	Yes
		6	Cascade Differential	22	No	No	Yes	Yes
PUMPS		1	System Pump Delay	22	No	No	Yes	Yes
	I
		2	SH Pump Delay	22	No	No	Yes	Yes
		3	DHW Pump Delay	22	No	No	Yes	Yes
NOTIFICATION
		1	Service Notification in Month	22	No	No	Yes	Yes
		2	Service Notification Running Hours	22	No	No	Yes	Yes
	J
		3	Service Notification Boiler Cycles	22	No	No	Yes	Yes
		4	Reset Service Notification Counter	22	No	No	Yes	Yes

NOTICE

The parameters for Building Management System operation are not listed in this table. They are only accessible using the PC interface software. See separate documentation for access information. See page 21 of this manual for a brief discussion.

16