Installation & Operation Manual
5 Hydronic piping
Figure
FROM
SYSTE
M
MAY SUBSTITUTE LOW LOSS HEADER 
HOT WATER
GENERATOR
WATER GENERATOR
CIRCULATOR
(TYPICAL)
HEAT EXCHANGER 1
BOILER PUMP
HEAT EXCHANGER 2
BOILER PUMP
NOTICE | A system supply sensor (factory | |
supplied) MUST BE installed for proper | ||
| ||
| boiler operation. |
BALL VALVE (TYPICAL)
AIR
SEPERATOR
DRAIN POINT (TYPICAL)
SYSTEM SUPPLY
SENSOR
SYSTEM
CIRCULATOR
PRESSURE GAUGE
BACK FLOW
PREVENTER
TO SYSTEM
MAKE UP
WATER
PRESSURE REDUCING (VALVE)
EXPANSION
TANK
|
| UNION (TYPICAL) |
|
| TEMPERATURE/ |
|
| PRESSURE GAUGE |
|
| PRESSURE RELIEF |
|
| VALVE |
FLOW CHECK |
| |
VALVE (TYPICAL) | TO FLOOR | (RECOMMEND) |
| DRAIN | (TYPICAL) |
NOTICE
NOTICE
Please note that these illustrations are meant to show system piping concept only, the installer is responsible for all equipment and detailing required by local codes.
System flow should always remain higher than the required flow for the boiler(s) when the boiler(s) is in operation to prevent short cycling and high limit issues.
32 
