Setup and cleaning
Only hold the housing for transporting and never the panel.
The front panel and the LCD screen underneath it are made of glass and may break if not properly handled. If the LCD screen is damaged (not the glass panel) and in case of leaking liquid crystal, wear rubber gloves to carry the device.
In case of contact with the skin, wash the affected areas thoroughly with water.
Note
100 |
mm |
Cleaning the front panel
| (Only for Spheros 32/37 HD) |
| The inside of the front panel and the LCD |
| screen need to be cleaned from time to time. |
| Only remove the front panel when the TV has |
| been switched off and has cooled down. The |
| metal frame of the LCD panel may reach a |
| temperature of up to 60°C in operation ! |
100 | ¥ Hold the glass panel at the bottom right |
mmand left and pull the panel out of the guide about 4 cm.
During the whole period of use, pixel errors may appear on the screen in the form of lighter or darker spots, this phenomenon is typical for an LCD display. It is not a defect.
¥Install the Spheros Signal Box and the screen with room for air circulation. The air vents may not be covered by objects such as magazines, table cloths, curtains etc.
100 mm
100 | 100 |
mm | mm |
.
¥Check the strength of furniture (e.g. tables, sideboards) before placing the set on it.
¥Take the swivel range into account when installing a set with a rotary motor unit.
¥Do not place naked flames, e.g. lit candles, on the set.
Note on installing the flat screen (LCD): Observe the enclosed installation instructions depending on the type of set you have purchased and installation.
With the Xelos SL 32 HD and 37 HD types a stand (Xelos table stand) is usually delivered for the LCD.
Handling the mesh tube
Use the enclosed mesh tube to lay the screen, base, wall holder or rack cables tidily and guide the hose with the cables to the Signal box. This looks more elegant.
The diameter of the mesh tube widens when it is pushed together lengthwise (see figure). This makes it easier to push through the cables with plugs.
.
¥Push the glass panel up evenly.
¥Unhook the glass panel at the top and remove.
Use a damp, soft cloth to clean the LCD screen and a glass cleaner for the glass panel.
Replacing the front panel:
¥Make sure you do not damage the LCD screen with the fastening bolts on the front panel.
¥Hang the glass panel into the guide rails at the top with both fastening bolts.
¥Then press the glass panel down lightly onto the screen until it snaps into place.
Clean the other components such as the remote control and signal box with a damp, soft cloth only (without aggressive and abrasive cleaning agents).
7
31963_021_RC3_GB | 7 | 14.01.2005, 10:40 Uhr |