Loewe 37 HD Connect LCD screen and antennae to the Signal Box, TFT-LCD monitor, Switch on/off

Connect LCD screen and antenna(e) to the Signal Box

TFT-LCD monitor	Removing the connection cover
	Do not just pull the cover (fig.) back
	over the connections.
	Reach into the opening in the cover
	and pull it back slightly at the top until
	it snaps open. Then pull the cover up
	and out.
	Connect both the system cables and
	the power cable to the LCD screen as
	shown in the figure.
	Then replace the cover.

Switch on/off

DVI-INPUT ✳✳ CONTROL AC INPUT D-SUB 220V-240Volt

Signal Box

ANT-2

PIP

	AV 2 ( RGB )					AV 1
L	R	L	R	L	R	Center Sub
AUDIO OUT		AUDIO IN 3		SOURROUND

	DIGITAL				VGA
					120-240V
		IN1	IN2	OUT
AUDIO IN1					50/60Hz
L	R				CONTROL
		Y		CB/PB
		CR/PR

SERVICE	RC5/	IR-	AUDIO	SYSTEM	DVI-INPUT	D-SUB		DVI-OUTPUT
	RC6	Link	IN 2				DISPLAY

TV R

✳The antenna sockets 1 and 2 are only available in the set version with ÓDigital-TV upgrade kit 2 Sat/Twin-Sat CIÓ. ✳✳ The connection socket ÓCONTROLÓ is only available for Spheros 32/37 HD and designed for a Motor Unit!

Note: For optimum picture resolution use the "Digital Visual Interface Input DVI" only connecting cables less than 2 meters long.

8

31963_021_RC3_GB 8 14.01.2005, 10:40 Uhr