Loewe 32 HD Initial installation, Batteries, Connecting, Switching on, Automatic programming

Initial installation

Batteries

To insert or change the batteries, press the point marked by an embossed arrow. Push the cover of the battery compartment down and remove it. Insert the batteries of the alkaline manganese type LR 03 (AAA) with the correct polarity (+/-).

+

+

Then push the cover back on.

Note on disposal of batteries:

The original batteries do not contain any pollutants such as cadmium, lead and mercury. Used batteries do not belong in the domestic waste. They must be taken to the appropriate collection points according to the national laws. Ask your dealer.

Connecting

Antenna

Connect your antenna or cable system to the UHF/VHF antenna socket on the back of the Signal Box.

¥In sets with the ÓDigital-TV Upgrade Kit 2 Sat/Twin-Sat CI- or CIPÓ connect the Sat antenna cable to the ÓANT-1Ó and ÓANT-2Ó sockets, in this way you can receive two satellite programs simultaneously, e.g. for PIP display, see fig. on page 9.

¥In sets with ÓDigital-TV Upgrade Kit 2-T/SÓ connect the antennae to the Signal Box as shown below.

ANT-1	AV 2 ( RGB )					AV 1
							DIGITAL
						AUDIO IN1
						L	R
PIP UH
	R	L	R	L	R	Center Sub
	OUT	AUDIO IN 3		SOURROUND
						SERVICE	RC5/	IR-
							RC6	Lin

Power mains

After connecting the flat screen to the Signal Box, connect both devices to 230V/60Hz mains sockets.

Switching on

Press the On/Off button so that it is pressed in. Due to the LCD technology it takes about 2 minutes to reach full brightness.

SPHEROS

.

Automatic programming

Automatic programming of the TV set is started the first time you switch it on. Follow the menus.

First you have to select the menu language for your set. Then you specify which antenna you have connected to your TV and in what country you are using it. Then you start the station search. The TV set searches for, saves and sorts all programs which are freely receivable on your antenna system.

You then see a list of the stored stations in which you can mark your favorites. Finally log in your video recorders, decoders, Loewe audio system and Home Automation with the connection wizard and connect these to the TV set according to the illustrated connection plan.

OK	Select the settings with the
	arrows on the ring ...
	... confirm the settings with
OK	OK. You then move on to the
	next menu ...

... press this button if you want information about the settings.

You can repeat initial installation at any time, e.g. after moving house. Call the index in the main information (i button). Then select the item "Repeat initial installation". Then start "Initial installation" with OK.

Switch on/off

9

31963_021_RC3_GB 9 14.01.2005, 10:40 Uhr