Loewe Auro 2216 PS manual Activate Digital Link, Switch over PAL/NTSC, Doing a reset

First installation

DVD menu

Language DVD Player Menu
Deutsch	D
English	GB
Español	E
Français	F
Nederlands	NL
Italiano	I
Accept with OK		Info
		Back
		End

Press the button OK .

The selected language is then set as Auro’s user interface language.

The DVD menu is closed when you press the END button.

Activate Digital Link

With Digital Link, Loewe TVs pass on the remote control signals to Auro via the Euro-AV connection. Digital Link is useful when you want to install Auro con- cealed, e.g. in a closed rack where it cannot be reached by the remote control signals.

Switching on Digital Link

Auro must be in standby (standby indicator lights red, display is dark). Hold the

button the device pressed for at least five seconds until the message LINK appears in the display.

Switching off Digital Link

Auro must be in standby (standby indicator lights red, display is dark). Hold the

button the device pressed for at least five seconds until the message FRONT appears in the display.

Switch over PAL/NTSC

Auro is set to the PAL TV norm at the factory. If your TV is set to another standard (NTSC), you have to adapt the Auro setting accordingly. There is no disc in the drive and the drawer is closed.

If Auro is switched on: keep the Pause button on the device

or on the remote control pressed for five seconds.

NTSC, appears in the device display, Auro is then set to the NTSC TV standard. In the same way, you can set the Auro to AUTO or PAL.

In the AUTO AUTO setting, Auro automatically detects whether a PAL or an NTSC-DVD is inserted and switches over to the respective standard.

Doing a reset

You can reset all settings in Auro to their original values with a Reset. The state prior to initial installation (Factory Setting) is reinstated.

If Auro is in standby mode (red standby indicator lights) and the remote control is set to the DVD/CD mode:

1. Press the button on the remote control and hold it down.

. Also press the button on the device and hold it down.

3.Keep both the buttons held down for at least 5 seconds.

Then, Auro switches on, the message RESET appears in the display. The

sub-device DVD/CD is active.

All settings are therefore reset to their original values. You have to perform initial installation.

Switching over to Progressive Scan

With the Progressive Scan mode you get the highest possible picture quality without flickering in the “Component Video” operating mode. Set the “VIDEO OUT SELECTOR“ switch on the back of Auro to the “COMP“ position. If Auro is switched on: Keep the stop button (there is no disc in the drive and the drawer is

closed. / no menu display) on the unit pressed for five seconds. P-SCAN ON, appears in the unit display so that Auro is switched to Pro-

gressive Scan mode.

In the same way you can set Auro to P-SCAN OFF.

- 12