1 4Installation
Surround Panel & Circuit Board Installation
N O T E : Attach the vent prior to installing the surround panels (& circuit board).
a
NOTE: When in place, the panels maintain a 3/8” gap around the fireplace.
e | Attach the surround panels to the insert by sliding the slots |
on each panel over the tabs on the side of the insert. |
Slot
Tab
Phillips
Screwdriver
Remove the circuit board from the rear hopper support. Disconnect the wiring harness from the circuit board (see step “d” below for a detailed view).
| b |
| Bend these block- |
| off plates as |
| shown (both |
| sides). When in |
Back of | position, they |
Side Panel | block the view |
| through the slots. |
| in the surround |
| panels. |
c |
Attach the circuit board |
with the four screws |
shipped with the insert. |
Phillips |
Screwdriver |
Right Side |
Surround |
Panel |
Run the power cord to the side along the front of the fireplace behind the side panel (do not route it under the insert).
Install the top panel so the joggle clips slide over f the tabs on top of the side panels and insert.
Tighten the set screws from the back side with a small standard screwdriver
Top Trim
Place the right side surround panel near d the insert and attach the wiring harness
to the circuit board.
Back Side of
Circuit Board
Pinch these tabs to remove the wiring harness.
If using a thermostat, attach the thermostat wires at this time.
Wiring Harness (disconnected in step “a”)
"L" Bracket
Top Panel
Right Side Trim
Optional Trim Installation:
Insert one leg of each "L" bracket into the top and side trim piece. Align the trim to form a precise corner, then tighten the two set screws with a small standard screwdriver. Slide the trim over the panels. Attach the double- back tape between the trim and panels at the bottom corners. This keeps the trim tight against the panel and prevents rattles.
Travis Industries | 4 0 5 0 5 0 9 | 1 0 0 - 0 1 1 4 5 |
