Lopi Yankee Bay Pellet Insert manual 6Specifications

6Specifications

Heating Specifications:

Approximate Maximum Heating Capacity (in square feet)*	800 to 2,250
Burn Rate (Pounds per Hour)**	1.7 to 5.5
Maximum Burn Time on Low Burn**	28 to 52 Hours
Hopper Capacity (based upon hopper extension position)	48 to 89 Pounds

*Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is also affected by the fuel size, quality, and moisture level.

**Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20% depending on fuel quality may occur.

Dimensions:

Center of 4” diameter Flue is 16-7/8” above the baseplate and 7-1/2” left of center

32”

26-1/2”

25-1/2” (allow 36” width for control board installation)

	25-3/4” to 20”
	See “Hopper Extension Set-up”
	for details.
45”	13-1/4” (allow 14” depth in the Fireplace)
12"	Fireplace Opening
	Door Opening
Electrical Specifications:
Electrical Rating	115 Volts, 3.6 Amps, 60 Hz
Watts During Start-Up Sequence	400 (approximately)
Watts During Operation	180 (approximately)

Fuel:

The unit is designed for wood pellets that comply with the standards set by the Association of Pellet Fuel Industry (density of at least 40 lbs. per cubic foot, 1/4" to 5/16" diameter, length no greater than 1–1/2", 8200 BTU's/lb., moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million). If the fuel does not comply to this standard, the unit may not operate as designed.

N O T E: This heater may use alternative fuel if equipped with the multi-fuel fire pot and properly maintained. See the publication “Multi-Fuel Pellet Fire Pot” for requirements (available from your Travis Industries, Inc. dealer).

EPA Compliance:

This heater is EPA exempt from Phase II requirements, but has been tested for emissions using EPA test methods by OMNI Test Labs.

Travis Industries 4 0 5 0 5 0 9 1 0 0 - 0 1 1 4 5