Lopi Yankee Bay Pellet Insert manual 8Installation, Hopper Extension Set-up

8Installation

Hopper Extension Set-up

This pellet heater has a variable-height hopper. This allows the hopper to be lowered for smaller fireplaces. Follow the instructions below to set the correct hopper extension position.

•Determine the correct hopper extension position following the directions below.

The unit will extend 14” into the fireplace. For setting the hopper, the maximum fireplace opening measurements have to be taken at 14” into the fireplace.

Hopper Extension Position

A (highest position)	25-3/4”
B (next highest)	24-1/2”
C etc...	23-3/8”
D etc...	22-1/4”
E etc...	21-1/8”
F (lowest position)	20”

•Remove the hopper top following the directions below.

Hopper Top

Remove the hopper top by removing the screws holding it in place.

1/4" Nutdriver

NOTE: with the hopper top removed, the hopper walls may be removed.

•Remove the hopper walls.

Travis Industries 4 0 5 0 5 0 9 1 0 0 - 0 1 1 4 5