Lopi Yankee Bay Pellet Insert manual 2Operation

2 2Operation

Start-Up Sequence

This stove utilizes a start-up sequence whenever the mode switch is changed or the heater is started when cold. This is to ensure proper operation through all possible settings and operational states (hot or cold, pellets burning or not burning, etc.). This sequence over-rides all user settings (except the "OFF" position) to set the auger feed rate to medium, the exhaust blower to high, and the igniter on. During this period the lowest “HEAT OUTPUT” light will flash.

"MANUAL AUGER" Button

This button turns the auger on. It is used to “prime” the auger after the hopper has run out of pellets.

"AUGER ON" Light

This light comes on when the auger is turning. This allows the operator to determine when the auger is turning.

"FAULT" Light

This light comes on when an error occurs:

•The stove runs out of pellets

•During initial start-up (for a split second) or for improper electrical frequency

•A start-up sequence that does not result in the heater coming up to temperature

To reset the fault light, turn the mode switch to off and re-start the stove.

DISCONNECT POWER BEFORE SERVICE

H

E REMOTE

AHIGH

TAUTO

MANUAL

OMED

U

T	AUGER
P
	LOW
U	FAULT
T

Fault Codes (for qualified service personnel only)

Fault and #2 (LOW) Light Flash = Flow Switch Fault

Fault and # 4 (MID) Light Flash = System Snap Disk Fault (pellets run out & stove goes cold)

Fault and # 6 (HIGH) Light Flash = Safety Snap Disk Fault

Power Outages

If a sustained power outage occurs while in "Manual", the heater will go to a "cool down" mode to vacate smoke once power returns. If the power outage was short, the heater will go to the start-up sequence. If in "Auto", the heater will re-start (if the room is cool).

!Because this heater relies upon a blower to evacuate the smoke, some smoke may enter the home during a power outage. To keep to a minimum, leave the door closed.

Travis Industries 4 0 5 0 5 0 9 1 0 0 - 0 1 1 4 5