Manuals / Lopi / Household Appliance / Indoor Fireplace

Lopi Yankee Bay Pellet Insert manual 6Maintenance, Opening The Door

Models: Yankee Bay Pellet Insert

1 40

Download 40 pages 38.74 Kb

Page 26

Image 26

2 6Maintenance

Bi-Weekly Maintenance (or every 10 bags of pellets) - Continued

Opening The Door

Phillips

Screwdriver

Swing open this panel to	Bracket	(attached to side of
Swing open this panel to		heater)
access the door latch (use
the tool if necessary).

	Pawl
Door Frame	Lock Nut

When securing the door, make sure the pawl fits over the bracket before tightening.

With the pawl free of the bracket, the door may be swung open.

NOTE: Do not overtighten the pawl. This can permanently damage the latch and prematurely wear out the door gasket.

Travis Industries

4 0 5 0 5 0 9

1 0 0 - 0 1 1 4 5

Page 26

Image 26

Lopi Yankee Bay Pellet Insert manual 6Maintenance, Opening The Door

Contents

Yankee Bay Pellet Insert Travis Industries 5 0 5 0 0 0 1 1 4 2IntroductionIntroduction Important Information Table of Contents 4Safety Precautions Safety Precautions Mobile Home6Specifications Installation7 8Installation Hopper Extension Set-upInstallation9 Re-install the hopper walls following the directions below0Installation Installation1 Venting the Pellet StoveOutside Air used for combustion 2InstallationMobile Home Requirements Not Enough Air Baffle InstallationRestrictor Adjustment Too Much Air4Installation Surround Panel & Circuit Board InstallationInstallation into a Masonry Fireplace Hint6Installation Installation into a Factory Built MetalLocation of Controls Safety NoticeOperation1 Starting the Heater for the First TimeTwo Modes of Operation 8OperationLoading Pellets To Start Manual ModeTo Adjust the Heat To Shut Down0Operation Auto ModeTo Adjust Room Temperature or Start the Stove Adjusting the Fan Speed Operation22Operation Inspect the Burn Maintenance2Daily Maintenance whenever using the heater Make Sure Pellets are Not Piling UpCheck Firepot for Clinkers 4MaintenanceCleaning the Firepot Cleaning the Optional Plated Surfaces Bi-Weekly Maintenance or every 10 bags of pelletsClean the Heat Exchange Tubes Vacuum Hopper6Maintenance Opening The DoorClean the Glass Check Baffles, Ashbox, Ashpan, Dispose Ash If Necessary8Maintenance Sweep Ash Into AshpanYearly Maintenance or every two tons 0Maintenance Clean the Vent make sure the heater and vent is coolDoor Alignment Maintenance3Door Seal 2Maintenance Adjusting the Door Hinge and LatchReplacement Parts Check for Air Leaks Around the Door, Glass, and Ashpan4Normal Operating Sounds Safety Label Serial NoLimited 7 Year Warranty Years 1 & 2 Coverage Parts & LaborOptional Equipment ThermostatOptional Log 8Optional EquipmentRemote Thermostat ZC Kit 9 9 2 0 0 1 4 0Index