LOREX Technology QLR-0440 Series instruction manual Hardware Installation, Port PCI Card Diagram

SECTION 2 - INSTALLATION INSTRUCTIONS

Hardware Installation

Before installing the VISTAPRO software, you must first connect the 4 Port PCI card and optional Alarm I/O Board (ACC-ALM) into your PC. The 4 Port PCI card has 4 Video inputs, allowing you to connect up to 4 cameras to your system.

The connections and board lay out are shown below.

4 Port PCI Card Diagram

Power Supply port GPIO port

DC+12V OUT 1

DC+12V OUT 2

DC+12V OUT 3

DC+12V OUT 4

Camera 1

Camera 2

Camera 3

Camera 4

Camera 1-4:RCA/BNC video inputs for connecting up to 4 cameras.

Power Out 1-4:Can be used as a power source for cameras (as an alternative to an external adapter – the power connectors are not included with this system, and can be purchased seperately as ACC-1200)

Power Supply: Connects to the supplied power cable, allowing for cameras to receive power directly from

the computer’s Main Board when using Power Out 1~4 and ACC-1200.

GPIO Port: Connects to the Alarm Block module (ACC-ALM) if being used.

NOTE #1:	In order to connect a 12V camera to the DC Power Out inputs, you will need the accessory Mini
	Plug Connector (ACC-1200). This connector is necessary because the power inputs on the
	PCI Card are smaller than conventional power inputs. Only 12V DC Cameras are supported.
NOTE #2:	The power supply feature of the PCI card allows for a neater set up by eliminating
	the need for further wires & adapters. However, this feature is not essential since the
	cameras can also receive power from an external power supply.

- 7 -