Lowrance electronic LMS-480DF, LMS-480M manual Assembling the transducer, Drilling mounting holes

Models: LMS-480DF LMS-480M

1 216
Download 216 pages 22.5 Kb
Page 28
Image 28

Bolt

Lock washer

Nut

Flat washer

Flat washer

Assemble transducer and bracket.

3.Assembling the transducer.

A. One-piece bracket: Once you determine the correct position for the ratchets, assemble the transducer as shown in the following fig-

ure. Don't tighten the lock nut at this time.

Metal

Nut washer

Rubber

Metal washer

washers

 

Bolt

Assemble transducer and bracket.

B. Two-piece bracket: Once you determine the correct position for the ratchets, assemble the transducer as shown in the figure in step 2B. Don't tighten the lock nut at this time.

4.Drilling mounting holes.

Hold the transducer and bracket assembly against the transom. The transducer should be roughly parallel to the ground. The trans- ducer's centerline should be in line with the bottom of the hull. Don't let the bracket extend below the hull!

Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.

Drill the holes. For the one-piece bracket, use the #29 bit (for the #10 screws). For the two-piece bracket, use the #20 bit (for the #12 screws).

20

Page 28
Image 28
Lowrance electronic LMS-480DF, LMS-480M manual Assembling the transducer, Drilling mounting holes