Lowrance electronic LMS-480DF, LMS-480M manual To remove an MMC, To add an MMC or SD Card

Both of these solid-state flash memory devices are about the size of a postage stamp. An SD card is slightly thicker than an MMC. As this manual went to press, MMCs were available in storage capacities of 8 MB, 16 MB, 32 MB, 64 MB and 128 MB. SD cards were available in capacities of 8 MB, 16 MB, 32 MB, 64 MB, 128 MB, 256 MB and higher.

Additional MMC cards are available from LEI Extras; see ordering in- formation inside the back cover of this manual. MMCs and SD cards are also available at many camera and consumer electronics stores.

The MMC slot is located in a compartment on the front of the case. The compartment door is located at the lower right corner. The following figure shows a close-up with the door opened.

MMC groove for card removal

Thumb

screw

Insert card face up,

this way

Memory card compartment with a 16 MB MMC card installed.

To remove an MMC

1.Open the card compartment door by unscrewing the thumb screw. The screw should only be finger tight. If it was over-tightened, use a thumbnail, a coin or a screwdriver to open the door.

2.Just press a finger against the label of the MMC and drag it from the slot.

3.Close the compartment door and fasten the thumb screw finger tight.

To add an MMC or SD Card

1.Open the card compartment door.

2.Grasp the bottom of the MMC and push the top of the card into the slot. Once the card is started, use your fingernails to slide it the rest of the way to the left, until it is firmly seated in the slot.

3.Close the compartment door and fasten the thumb screw finger tight.

40