Chapter 4: SAS Domain Manager Command Line Interface Sample Output for Show Com-

LSISAS6160 SAS Switch User Guide

mand

 

4.3Sample Output for Show Command

4.3.1show alias

4.3.2show alias <alias>

4.3.3show device

NOTE: Zoning within the domain is disabled when no zone set is active, and access is unrestricted. Therefore, all end devices in the domain can see one another.

„zoneset delete single <name>

Deletes a single zone set.

„zoneset delete all [noconfirm]

Deletes all zone sets. If you specify the [noconfirm] option, the action occurs immediately without an additional confirmation prompt. Otherwise, SDM first prompts you to confirm the action.

„zoneset passwd

Starts a dialog to change and synchronize the password on all zoning expanders throughout the domain. Passwords are text strings that contains any valid ASCII character. The maximum password length is 32 characters.

NOTE: The default zone manager password is lynx.

„zoneset remove <name> <zone group> <zone group>

Removes communication privileges between two zone groups in an existing zone set. A zone group is purged from the zone set if no other communication privileges remain.

„zoneset rename <old> <new>

Renames an existing zone set.

This section shows sample output for some variations of the show command. The first line of each example shows the actual syntax of the command that you enter at the SDMCLI> prompt.

The examples in this section detail the show command output.

SDMCLI> show alias

 

SAS Address

Alias

-----------------------------------------------------

500605b0006b75b0

Bacchus

50012be0000380ff

Calhoun

500605b0000220bf

Carrollton

SDMCLI> show alias Calhoun

SAS Address

Alias

------------------------------------------

50012be0000380ff Calhoun

SDMCLI> show device

NOTE: In the following example, ZExpander means zoning capable expander.

Page 66

LSI Corporation September 2010

Page 66
Image 66
LSI SAS6160 manual Sample Output for Show Command, „ zoneset passwd, Sdmcli show alias Calhoun, Sdmcli show device